What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 02.07.2025 06:20
For this case there are devices called Metal oxide varistors (MOV).
[old diagram got deleted by accident]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
With a series of wars, Israel's military reshapes the Mideast - NPR
so, what happens?
At least they know the answer if they wanted it.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The Best Deals Today: Indiana Jones and the Great Circle, Nintendo Switch OLED, and More - IGN
There are three different concepts here that are getting confused.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Elon Musk’s Neuralink closes a $650M Series E - TechCrunch
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The third is lightning and “how it gets conducted into a home.”
I post the exact comment here.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
First Sentence:
Culpa maxime qui ut ut aut in.
A fuse is a non-resetable over current circuit protector.
These devices are installed between the “hot” and “neutral” and protective ground.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What are the challenges associated with the birth narratives of Jesus?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This device then solves the entire problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[image of Common-mode choke]
The MOV will conduct when the voltage exceeds 50% of line voltage.
Why hasn't Japan legalized same-sex marriage?
These are simplified answers to the original question, and does not change anything I wrote above.
2024–10–16 [ OO OLAOYE OYEBODE ]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
It seems Mohan does not understand the difference between a comment and an Answer.
It also is a device that limits the change in current flow.
Consectetur assumenda in molestiae debitis accusamus quaerat consectetur.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
but this device (an Inductor) … impedes the rapid changes in the current.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Man thought he was 'tired from work' before brain tumour diagnosis - BBC
eight
In schematic diagrams this is the symbol for a fuse:
Barnstars:
This is 'the assistant's answer'
A circuit breaker is similar, but is resettable.
There are two important concepts here.
but I think this circuit , shows a few more pieces.
This is where the MOV conducts again, and dissipated the energy.
2024–10–14 [Omar Gharbi Omar Gharbi ]
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–10[John johnson John Johnson ]
This one hit behind the barn.
He then describes Rainy Season and Lightning.
So, the voltage could go up to 500 volts, and the fuse will not open up.
the problem then depends on "how fast does the fuse operate?".
Now when you have a certain ac resistance, then a current flows in a loop.
Here is a simplified AC power diagram.
(Dc diagram shown, AC is similar).
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
The other is “what does a “fuse” do?”
This is the picture of an electronic coil of wire wound around a core of magnetic material.
a photo is worth a thousand words.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
What does a fuse do?
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
He then describes the function of a fuse.
nine
what exactly is a ‘surge’ protector?
He then asserts :
This is where this question deviates from being a 'generic' question, and becomes more specific.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
But… the neutral is now “floating” because of the 1 ohm resistance.
An AC voltage/ current source, and an ac inductive load.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
What is lightning?
One
Because the load is inductive, the current lags the voltage.(by a bit).
One is “what exactly is in a ‘surge protector’ ? ”
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Edit 2024–10.
Upvotes:
The bolt then partially travels down the line to your home.
But it can get overloaded, and no longer works.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".